Battery Replacement - Beha-Amprobe 2100-Delta Manuel De L'utilisateur

BATTERY REPLACEMENT

In case of discharged batteries, the LCD will start blinking
" ". Replace the batteries.
• Disconnect the voltage tester completely from all
measuring circuits.
• Using a screwdriver, unscrew the metal screw on the
battery compartment until the battery compartment
cover can be removed.
NOTE: Do not unscrew the screw completely.
• Remove used batteries.
• Insert new batteries, type 1.5 V IEC LR03. Ensure that
the polarity is correct.
• Correctly insert battery compartment cover and
screw down.
W
If batteries have leaked, the instrument must no longer be
used and must be tested by our Factory Service Department
before it can be used again.
W
Never attempt to dismantle a battery cell! The electrolyte
in the cell is extremely alkaline and electro conductive. Risk
of chemical burns! If electrolyte comes into contact with your
skin or clothing, these spots must be rinsed immediately with
water. If electrolyte gets into your eyes, rinse them immediately
with clean water and consult a doctor. Please bear this in
mind and also consider our environment. Do not throw used
batteries into the normal household waste, but hand the
batteries over to hazardous waste facilities or hazardous waste
collection centers.
W
Observe the currently valid national or local regulations
concerning the return, recycling and disposal of used batteries
and accumulators.
W
Do not use the voltage tester with open battery compartment!
14