Gas Conversion Operation - Forno Alta Qualita FFSGS6211-30S Guide D'installation

After Installation:
1. Check ignition of surface burners.
2. Check the air shutter adjustment – sharp blue flame, with no yellow tipping or lifting flames.
3. Check ignition of oven burner.
4. Visually check tubular burner (oven burner) re-ignition to be sure both rows of burner ports are relighting each
time.
5. Check for gas leaks at all gas connections (using a gas detector, never a flame).
6. Check oven bake and convection bake function. (For some models have convection fan.)

Gas Conversion Operation

This cooking range can be used with LP gas and NG gas. It is shipped from the factory adjusted for use with NG
(Nature Gas). Injector for LP gas are included. Follow the instruction shown below for gas conversion.
WARNING
WARNING
The gas conversion procedure for this range includes 7 steps:
1. Pressure regulator
2. Surface burners
3. Oven burner
4. Broil burner
The conversion is not completed if all 8 steps have not been concluded properly.
Before performing the gas conversion, locate the package containing the replacement injectors shipped with every
range.
STEP 1: Pressure Regulator
The regulator was pre-installed on the back side of the Gas Range.
Gas conversion shall be conducted by a factory- trained professional. Call the
customer service hotline to identify a factory-trained professional near your
Counter top
home.
Before carrying out this operation, disconnect the range from gas and
electricity. Fail to do so, may result in fire, or electrical shock hazard can occur
and result in injury or death. Do not remove regulator or allow it to turn during
servicing.
5. Gas valves
6. Reconnect Gas and Electrical Supply
7. Installation of new rating label