Motorola Solutions CLP Serie Mode D'emploi page 4

To initiate pairing:
1. With the radio turned OFF, hold down the PTT button, then press and hold the power button until the illuminating red LED turns
solid blue.
2. The purple/blue LED sequence displays when pairing is complete.
Note: The CLP radio uses proximity pairing. Make sure the headset is within 3 – 6 inches of the CLP radio. Pairing process takes up to 60 seconds.
Do not press any other button.
Bluetooth Pairing PIN code is only applicable for Legacy headsets (Bluetooth 2.0 and before). The CLP Bluetooth PIN code is defaulted to
'0000'. Please refer to your Bluetooth Headset manual to confirm if a different pin code is required, in which case you should use the CLP CPS
to input new PIN code to allow pairing.
Reconnect to Last Connected Bluetooth Headset
With the Bluetooth Headset powered ON:
1. Turn the radio OFF.
2. Unscrew the wired accessory from the radio.
3. Press and hold the power button to turn the radio ON.
Erase Bluetooth Headset history and add Bluetooth Headset
Prior to pairing, make sure to:
1. Turn the radio OFF by pressing and holding the power button until the red LED on the Smart Status Glow blinks once.
2. Unscrew the wired accessory from the radio.
3. Put the Bluetooth Headset in pairing mode (refer to the Bluetooth Headset instructions leaflet).
To initiate pairing:
1. With the radio turned OFF, hold down the MENU button, then press and hold the power button until the illuminating red LED
turns solid blue.
2. The purple/blue LED sequence displays when pairing is complete.
2
English