Allmatic BIOS2 ECO Guide Pour L'installation page 24

9. Motors
The correct functioning is guaranteed only in the event of Allmatic motors.
For a greater safety, it is suggested to insert a fuse (T 3,15A) in series to the common of both the motors.
It is available a pre-wired kit (optional) that can be inserted as shown in the drawing below.
Avoid putting the connection cables of buttons, security devices and inputs close to those of the power supply of the control unit and of the motor.
Some
parts of the control unit are subject to dangerous voltage. The control unit must be installed and programmed only by qualified professionals. Always
use
a device that ensures the disconnection of all poles of the control unit's power supply.
This device can be:
- A switch (connected directly to the power supply terminals) with a contact's minimum distance of 3 mm for each pole.
- A device connected to the power network.
For connecting the card and the motors we recommend to use cables with double isolation as in compliance to the laws in force; the minimum cross
section of the single conductor must not be less than 1,5 mm² and not more than 2.5mm².
WEEE - Information for users
If the crossed-out bin symbol appears on the equipment or packaging, this means the product must not be included with other general
waste at the end of its working life. The user must take the worn product to a sorted waste center, or return it to the retailer when pur-
chasing a new one. Products for disposal can be consigned free of charge (without any new purchase obligation) to retailers with a sales
area of at least 400 m
An efficient sorted waste collection for the environmentally friendly disposal of the used device, or its subsequent recycling, helps avoid
the potential negative effects on the environment and people's health, and encourages the re-use and/or recycling of the construction materials.
GUARANTEE - In compliance with legislation, the manufacturer's guarantee is valid from the date stamped on the product and is restricted to the
repair or free replacement of the parts accepted by the manufacturer as being defective due to poor quality materials or manufacturing defects. The
guarantee does not cover damage or defects caused by external agents, faulty maintenance, overloading, natural wear and tear, choice of incorrect
product, assembly errors, or any other cause not imputable to the manufacturer. Products that have been misused will not be guaranteed or repaired.
Printed specifications are only indicative. The manufacturer does not accept any responsibility for range reductions or malfunctions caused by
environmental interference. The manufacturer's responsibility for damage caused to persons resulting from accidents of any nature caused by our
defective products, are only those responsibilities that come under Italian law.
6-1622176 rev.8 12/09/2022
WARNING AND ADVICES
2
, if they measure less than 25 cm.
ALLMATIC S.r.l
32026 Borgo Valbelluna (BL) – Italy
Via dell'Artigiano, n°1 – Z.A.
Tel. 0437 751175 – 751163 r.a.
http://www.allmatic.com - E-mail: info@allmatic.com
ITA ENG
Fax 0437 751065
FRA ESP DEU POR
12 / 12