Normal Functioning - Allmatic BIOS2 ECO Guide Pour L'installation

7. Display and control unit state

7.1 Normal functioning:

Standby - Gate closed
Opening phase
Closing phase
Gate closed by user during opening
Gate closed by user during closing
Gate stopped by an external event (fotocellule, stop)
Gate opened without automatic reclosing
Gate opened in partial opening position without automatic reclosing
Gate opened waiting for auto reclosing, last 10 seconds the dash will be replaced by the countdown
Gate opened in partial opening position waiting for auto reclosing, last 10 seconds the dash will be replaced
by the countdown
During the normal functioning and out from any menu, the pression of the DOWN[-] button lets you see the
number of cycles done, you will see units with dots on the bottom of display and thousand without dot,
another pression of DOWN[-] or MENU button let you to leave the cycles visualization
Visualized during the learning of transmitters
Visualized when memorized a new transmitter or at the and of a reset
Visualized when memorized a key of a transmitter already memorized
Visualized when a trasmitter is erased
Visualized during the learnign of strokes to indicate that the control unit is opening the gate and waiting for the
command of opening mechanical stop
Visualized during the learning of strokes to indicate that the control unit is clkosign the gate and waiting for the
command of closing mechanical stop
Visualized during the learning of strokes if there is an intervention of safety devices
Visualized when the control unit waits a transmitter signal, during the function of viewing of the memory
location.
Visualized when the transmitter is not stored on the memory, during the function of viewing of the memory
location.
Visualized when the control unit exits from the function of viewing of the memory location for inactivity.
7.2 Errors:
Limit switches error (both opening and closing electrical limit switches busy in the same time)
Malfunctioning of photocells
Memory error
Full memory
Memory error during functions viewing memory location or cancellation of a single transmitter
The visualization of an error on the display persist until another command is given
6-1622176 rev.8 12/09/2022
ITA ENG FRA ESP DEU POR
10 / 12