CRZ E-MD04 Manuel Utilisateur page 47

Vehicle runs Sluggishly.
Sometimes the vehicle
doesn't run, but other
times it does.
Charger gets warm
During use
Vehicle does not Stop
when applying the
brake.
Vehicle makes loud
noises or grinding
sounds
Brakes are not adjusted
properly
Driving conditions are too
stressful.
Tires are not properly
Inflated.
Vehicle is overloaded.
Loose wires or connectors
Motor or electrical Switch
damage.
Normal response
Charger use
Brakes are not adjusted
properly
Chain is too dry
Refer to brake adjustment instructions.
Use only on solid, flat clean and dry Surfaces such as
pavement or level ground.
The tires are inflated when shipped, but They invariably
will lose some pressure Between the point of
manufacturing and your purchase. Refer to tire
instructions to properly inflate tires.
Make sure you do not overload the vehicle by allowing
more than one rider at one time, exceeding the
maximum weight limit, going up too steep a hill or towing
objects behind the vehicle. If the vehicle is overheated,
the temperature circuit protector will slow motor down
and if the condition continues, will shut off power to the
motor. Correct the driving conditions that caused the
overheating, wait 5-10 minutes and then resume riding.
Avoid repeatedly overheating the unit.
Check all wires around the motors and all connectors to
make sure they are tight.
Contact the authorized service center for diagnosis and
repair.
No action required. This is normal for some Chargers
to and is no cause for concern. If your charger dose not
get warm during use, it does not mean that it is not
working properly.
Refer to brake instructions to properly adjust Brakes.
Apply a lubricant to the chain.