CRZ E-MD04 Manuel Utilisateur page 41

habit of inspecting yours regularly.
❑
Tire Inflation
Periodically inspect the tires for excess wear, and regularly check the tire pressure and re-
inflate as necessary. If you get a flat tire, the inner tube can be patched or a new tube can be
purchased from an authorized repair shop.
❑
Safety Gea
r
Always wear proper protective equipment such as an approved safety helmet, elbow pads
and kneepads. Always wear shoes (lace-up shoes with rubber soles), never drive barefooted
or in sandals, and keep shoelaces tied and out of the way of the wheels, motor and drive
system
ATTENTION
We recommend checking all tightened parts after the first time use. Special attention should be
paid to the following parts:
■ Footrest
■ Engine sprockets (Racing version only)
■ Shock absorber
■ Engine bolts and nuts
■ Rear sprocket
TECHNICAL SPECIFICATION SHEET
Motor type
Battery
Charger
Non-load input current
Maximum motor current controller
output
Under voltage protection value
Charge output current
Transmission
Front suspension
Rear suspension
Tyre
Brake system
Rated loading capacity
Max. speed
Range per charge
Dry Weight
Dimension (mm)
Seat height (mm)
Min. Ground Clearance(mm)
Wheelbase (mm)
500W 24V
2 x 12V 12A lead acid battery
100-240V/50-60 Hz/1.5A
≤115mA
28A±1.0A
23.5V±0.5V
27.6V-1.5 A
Chain drive
Telescopic fork
mono shock absorber
front & rear 2.50-10 with 7.00 P.s.i operation
pressure and 36 P.s.i Max. inflate
front and rear disc brake with mechanical control
60KG
24KM/hour
15km
30kgs
1210×570×800
580
220
820