CRZ E-MD04 Manuel Utilisateur page 37

ASSEMBLYNUMBER BOARD
ASSEMLY FRONT WHEEL AND REAR SHOCK ABSORBER
mount the bolt (D) through the
3.
mudguard fixing bracket into the
splintage (B) and tighten it.
mount the bolt (C) bottom-up through
4.
the mudguard rear hole into the
splintage (B) and tighten it.
A：mudguard
B：down splintage
C：bolt M6X16
D: bolt M6 x16
3. Fix the number board (A) into the
location pillar of mudguard (E)
4. Install the bolt (C), bush (D) into the
upper splintage (B) and tighten the bolt
with 10mm socket spanner.
A：Number board
B：upper splintage
C：bolt M6X25
D：bush 8X1.0X15
E：location pillar
3. put the wheel (A) on the right position to
place the disc (E) between the brake
caliper pad.
4. mount the axle (B) through the left fork,
bush (D), wheel, bush (D) and right fork
in sequence, and then fix the nut (C)
and tighten it.
A：wheel
B：wheel axle M12X160
C：nut M12
D：bush 16X1.5X13 2pcs
E：brake disc