CRZ E-MD04 Manuel Utilisateur page 38

INFLATING THE TIRES
NOTE: The tires are inflated when shipped, but they invariably lose some pressure between
the point of manufacturing and your purchase. Always inflate the tires to the correct PSI
before first time use.
Please read the specification sheet to get the information of tire pressure.
Using a bicycle-style tire pump to inflate the tire to the PSI indicated on the sidewall of the tire.
Note: The pressurized air supplies found at gasoline stations are designed to inflate high-
volume automobile tires. If you decide to use such an air supply to inflate your tires, first make
sure the pressure gauge is working, then use very
short bursts to inflate to the correct PSI. If you inadvertently over-inflate the tire, release the
excess pressure immediately.
Important information of use guider for tire
Note: Tire is the only contact between the vehicle to the road, the safety of various driving
activity depends on the small area of tire where contact with the road. Therefore, it is very
important to keep the tire in good condition any time and use the correct size and standard
tire to replace the old ones.
Guide:
Tire assembly and disassembly
It is strongly recommended that the tire assembly and disassembly should be done by an
authorized technician with necessary skills.
Tire inflating pressure
It is very important to keep the tire in proper pressure and check the tire pressure before use.
1. Uplift the frame to align the shock (A)
mounting hole to the shackle joint hole.
2. Fix the bolt (B) through the shock
mounting hole and shack joint and tighten
the nut (C) securely with 10mm and 13mm
open end wrench
A：shock absorber
B：bolt M8X40
C：nut M8