CRZ E-MD04 Manuel Utilisateur page 44

alignment and then re-attach the chain cover.
Adjusting brake
Check
To check the wear of front and rear brake pads A, simply inspect the brakes calipers as shown
in the below picture.
Warning:
Step 1:
To adjust the brake tension, thread the brake lever
adjuster in or out 1/4 or 1/2 turn until the required brake
adjustments is attained.
Most of brake adjustments are complete at this step, if
the brake still need the further adjustment,
Step 2:
With 10mm open spanner, loose the brake cable and
adjust the brake caliper arm to make the cable
>30mm
length from arm to the pillar.
Step 3:
With 8mm open spanner to loose the nut of friction
pad, and with 2.5mm allen wrench to adjust the inner
screw for friction pad.
The thickness of the lining on the ends of the four pads
should never be less than 1mm.
Should the lining be thinner, immediately replace the
brake pads.
We recommend having the brake pads replaced by
an authorized dealer.