SSS Siedle CAB 850-1 Information Produit page 19

Programming – manual
Programming door calls
Application
Call from the door station to an
indoor device.
The call tone volume can be set
on the indoor device (see AIB/
VIB 150-... operating instructions).
1 Activate the programming mode
on the SNG 850-... Briefly press the
programming mode button, LED 1
flashes every 2 seconds.
4 On the door station, press and
hold the desired call button for
4 seconds until a sustained tone can
be heard from the door loudspeaker.
The call button is now assigned to
the bus indoor device.
2 At the door station, hold down the
programming button for 4 seconds.
A protracted acknowledgement tone
is then audible which is repeated
every 5 seconds as long as the pro-
gramming mode remains active.
5 The call button is now firmly
assigned to the bus indoor devices.
Program additional users using the
same procedure or quit the pro-
gramming mode.
3 Hold down the speech button for
4 seconds. A protracted acknowl-
edgement tone sounds as confirma-
tion and the muting LED begins to
flash. The bus indoor device estab-
lishes the speech connection to the
door station. The bus indoor device
is now in the programming mode.
19