Maico EZR B Série Instructions De Montage Et Mode D'emploi page 15

Modifications and alterations to
the unit are not permitted and
release the manufacturer from
any guarantee and liability.
WARNING
Danger of electric shock
Disconnect the unit, at all poles,
from the power supply before
removing the terminal box
cover. Position a visible sign
warning against being acci-
dentally switched back on.
Only operate the unit when it is
completely installed.
Note the voltage and frequency
stated on the rating plate.
The degree of protection stated
on the rating plate is only
guaranteed if the unit is installed
as intended.
Only connect unit to
permanently wired electrical
installations with NYM-O or
NYM-J (3 x 1.5 mm² or
5 x 1.5 mm²) cables. Install a
mains isolation device with
contact openings of at least
3 mm at each pole.
Humidity which penetrates the
unit can cause electric shock
and damage the unit. The
degree of protection can no
longer be guaranteed.
1. Safety instructions │ UK
Correctly install electric
connection cables with cable
grommet provided so that the
cable sheathing is fully enclosed.
The terminal box cover must be
correctly fitted, so that the
surrounding sealing has close
contact all the way around the
terminal box
In the case of damage
Repairs, which are not
performed correctly, are
dangerous. Only electricians
may perform repairs and
replace connecting ducts. If the
unit is defective, switch off the
fuse in the fuse box and get
customer service involved.
13