Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
3.
Discontinue tool use if it does not work properly or air is leaking.
Tag or mark the tool as 'defective' or 'out of service' until repaired.
4.
Check the manufacturer's maximum pressure rating for air tools
and accessories. Compressor outlet pressure must be regulated to
never exceed the maximum pressure rating of the tool (see
Specifications). Exceeding the maximum PSI rating can create a
bursting hazard, causing injury and property damage.
5.
Attach all accessories properly to the tool before connecting the air
supply. A loose accessory may detach or break during operation.
6.
Never use oxygen, combustible gas or any other bottled gas as a
power source. Any power source other than an air compressor
could cause an explosion and serious personal injury.
7.
Turn OFF the valve and discharge any remaining air pressure after
each use or before adjusting the tool.
8.
Do not leave the air tool unattended with its compressed air supply
on. Turn off the compressed air supply and bleed the air tool of any
remaining compressed air before leaving the air tool unattended.
9.
Serious injury may occur from loose debris being propelled at high
speeds from the compressed air stream. Always wear OSHA
approved safety glasses to protect the eyes during operation of the
air compressor.
10. Always turn off the air compressor and drain tank pressure
completely before attempting maintenance or attaching air tools.
Release pressure slowly from the system.
AIR HOSE PRECAUTIONS
1.
Inspect the tool's air hose for cracks, fraying or other faults before
each use. Discontinue use if the air hose is damaged or hissing is
heard from the air hose or couplers. Replace the defective air hose.
2.
Do not allow people, mobile equipment or vehicles to pass over the
unprotected air hose. Position the air hose away from high traffic
areas, in a reinforced conduit or place planks on both sides of the
air hose to create a protective trench.
3.
Prevent damage to the air hose by observing the following:
a.
Never carry the tool by the air hose.
b.
Keep the air hose behind the tool and out of the tool's work path.
Visit www.princ essauto.com for more inform ation
1/4 in. Extended Air Die Grinder
9029893
5
Publicité
Table des Matières
