Front: Description Of The Controls; Controls For Input Channels - AKG DMM8 U Mode D'emploi

Description
Front controls
Rotary knobs for
inputs
LED ON
LED PEAK
DMM8 MANUAL
5.3

Front: Description of the controls

There is a total of nine controls on the front.
8 8
ON PEAK ON PEAK ON PEAK
IN 1 / USB L IN 2 / USB R IN 3 / DANTE 1
EQ 250 Hz / 2.0 kHz EQ 350 Hz / 2.8 kHz EQ 500 Hz / 4.0 kHz
2
1
Figure 1: Front of the DMM8 U (UL, ULD)
The following table describes the controls on the front of the
DMM8 U (UL, ULD):
No. Description
1 to 6 Microphone or line inputs
7 Operating mode / System Control
8 Stereo output
9 Modulation display for stereo outputs
10 Stereo headphone output
11 Socket for headphone connection
The parameters of the selected audio functions are changed using the
controls.
5.3.1

Controls for input channels

The DMM8 U (UL, ULD) has 6 balanced input channels to connect low ohm,
dynamic microphones or capacitor microphones and other signal sources,
e.g. receivers for wireless microphones. There is a control for each input
channel (1 to 6).
Each input channel has a green LED ON and a red LED PEAK.
ON is lit when the input channel is prioritized in automatic mode. If the auto-
mix function is switched off, ON is lit continuously.
PEAK is lit if the signal on an input channel comes close to the maximum
modulation limit. In this case, the level should be reduced or the input sensi-
tivity changed.
8 8 8 8
ON PEAK ON PEAK ON PEAK
IN 4 / DANTE 2 IN 5 / DANTE 3 IN 6 / DANTE 4
EQ 700 Hz / 5.6 kHz EQ 1.0 kHz / 8.0 kHz EQ 1.4 kHz / 11.3 kHz
3 4 5 6
8 8
PRIORITY
AUTOMIXING PAN / BALANCE
COMPRESSOR DELAY
LIMITER ROUTE TO REC
LOW CUT ROUTE TO USB
BASS EQUALIZER LOW
TREBLE EQUALIZER HIGH
OUT HEADPHONE
LEVEL PRESET
L
LOCKED IN USB / DANTE
-50 -40 -30 -20 -10 -5 0 +5 dB
R
SYSTEM CONTROL
7 8 9 10 11
77