Microphones, Guitar Cable; Placing The Receiver; Inserting And Testing Batteries - AKG WMS40 Mode D'emploi

2.7 Microphones, Guitar Cable

(optional)
You can connect the following micro-
phones to the audio input of the PT 40:
C 417 L C 419 L
C 420 L D 409 L
C 444 L CK 55 L
The MKG/L guitar cable from AKG lets
you connect an electric guitar, electric
bass, or remote keyboard to the body-
pack transmitter.
2.7 Color Code Table
Frequency
US54: 710.400 MHz
US58: 734.600 MHz
KR3: 745.650 MHz
KR4: 750.900 MHz
EU62: 802.525 MHz
EU63: 812.800 MHz
UK69A: 854.900 MHz
Frequency
UK69B:
ISM1:
ISM2:
3 Setting Up
C 411 L
C 418 L
LM 3 L
Important: Prior to setting up your
WMS 40, check that the transmitter
and receiver are tuned to the same
frequency. The easiest way to do this
is to compare the color codes on the
transmitter and receiver.
Color

3.1 Placing the Receiver

reddish brown
purple Reflections off metal parts, walls, cei-
mint green
lings, etc. or the shadow effects of musi-
dark gray
cians and other people may weaken or
Bordeaux red
cancel the direct transmitter signal.
yellow
For best results, place the receiver as
violet
follows:
Color
858.200 MHz green
863.100 MHz melon yellow
864.375 MHz gray
1. Place the receiver near the perform-
ance area (stage). Make sure, though,
that the transmitter will never get any
closer to the receiver than 10 ft (3 m).
Optimum separation is 16 ft. (5 m).
2. Check that you can see the receiver
from where you will be using the
transmitter.
3. Place the receiver at least 5 ft. (1.5 m)
away from any big metal objects,
walls, scaffolding, ceilings, etc.

3.2 Inserting and Testing Batteries

(Refer to figs. 1 to 3)
Important: The foam pads on the inside
of the battery compartment lid holds
the batteries in place. Do not remove
the foam pad. If you do, the batteries
will not be held in place properly and
may cause a rattling noise.
1. Depress the snap hook on the battery
compartment lid (6).
13