GYS Energy 124 Mode D'emploi page 13

Translation of the original instructions
TROUBLESHOOTING
Symptoms
The machine's voltmeter does
not luctuate.
The charger is properly
connected but it does not
charge the battery
The fuse blows every time it
is replaced
ENERGY 124, 126
Causes
No mains voltage
Clamps in short circuit or polarity
reversal.
Blown fuse
Blown fuse
Bad clamp connections.
Following intensive use, your
device has entered thermal
protection mode.
Polarity reversal
Starting the vehicle
Current overconsumption on the
battery
Remedies
Check that the power cord is plugged to a
230V 50/60Hz socket. Check the power supply
network.
Remove the clamps. Check that the fuses have
not melted and that the circuit breaker is not
tripped
Replace the fuse by a new one.
Replace the fuse by a new one.
Clean the terminals and the clamps. Check the
state of the cables and clamps.
Wait 1/4h so the device can cool down.
Connect the + clamp to the battery's (+) and
the + clamp to the battery's (-).
Do not perform any starts when the charger is
connected.
Do not draw any of the battery's current during
the charge
EN
13