Mounting The Bar Speaker On A Wall - Sony HT-ST5 Mode D'emploi

Mounting the Bar Speaker on a wall

You can mount the Bar Speaker on a wall.
Notes
 When you mount the Bar Speaker on the wall, detach the stands
beforehand (page 6).

Prepare screws (not supplied) that are suitable for the wall material and
strength. As a plasterboard wall is especially fragile, attach the screws
securely to two studs in the wall beam. Install the Bar Speaker
horizontally, hung by screws in studs in a continuous flat section of the
wall.
 Be sure to subcontract the installation to Sony dealers or licensed
contractors and pay special attention to safety during the installation.
 Sony shall not be held responsible for accidents or damage caused by
improper installation, insufficient wall strength, improper screw
installation or natural calamity, etc.
1
Prepare screws (not supplied) that are suitable for the holes
on the rear of the Bar Speaker.
4 mm (3/16 in)
More than 30 mm (1 3/16 in)
4.6 mm
(3/16 in)
10 mm
(13/32 in)
Hole on the rear of the Bar Speaker
2
Fasten the screws to two studs in the wall.
The screws should protrude by 8 mm to 9 mm (approx. 11/32 in).
846 mm (33 3/10 in)
8 mm to
9 mm
(approx.
11/32 in)
3
Hang the Bar Speaker on the screws.
Align the holes at the rear of the Bar Speaker with the screws,
then hang the Bar Speaker on the two screws.
Note
When you use an HDMI IN 3 jack of the wall-mounted Bar Speaker,
connect the swivel-type High Speed HDMI cable.
7
US