Installing The System; Installing The Bar; Speaker And; Mounting The Bar Speaker On A Wall - Sony HT-G700 Mode D'emploi

Installing the System

Installing the Bar

Speaker and Subwoofer
Refer to Startup Guide (separate
document).
Mounting the Bar
Speaker on a Wall
You can mount the bar speaker on a
wall.
Notes
• Prepare screws (not supplied) that are
suitable for the wall material and
strength. As a plasterboard wall is
especially fragile, attach the screws
securely in the wall beam. Install the
speakers horizontally, hung by screws in
studs in a continuous flat section of the
wall.
• Have the installation done by a Sony
dealer or licensed contractor and pay
special attention to safety during the
installation.
• Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
disaster, etc.
GB
12
1
Prepare two screws (not supplied)
that are suitable for the wall
mount holes on the rear of the bar
speaker.
More than 30 mm
Hole on the rear of the bar speaker
2
Stick WALL MOUNT TEMPLATE
(supplied) on a wall.
Center of the TV
Adhesive tape,
etc.
1
Align TV CENTER LINE () of
WALL MOUNT TEMPLATE with the
center line of your TV.
2
Align TV BOTTOM LINE () of
WALL MOUNT TEMPLATE with the
bottom of your TV, then stick
WALL MOUNT TEMPLATE on a
wall by using a commercially
available adhesive tape, etc.
4 mm
5 mm
9 mm
WALL MOUNT
TEMPLATE