Remote Control; Before Operation - Aiwa XR-DV3M Mode D'emploi

REMOTE CONTROL

Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
Using the remote control
Some operations can be performed using the buttons on the
remote control only, or those on the main unit only, while others
can be performed using the buttons on the main unit as well as on
the remote control. This instructions manual clearly describes
the buttons available for each operation.
c/d on the remote control
The function is the same as that of c on the main unit.
Using the SHIFT button
To use the 6 to 0, +10 and C buttons as the PBC, MONO TUNER,
BAND, KARAOKE, TIMER, SLEEP, and CLOCK buttons, press
the button while pressing the SHIFT button.
Also, to use the i/k buttons as the MONITOR ANGLE buttons,
press the button while pressing the SHIFT button.
SHIFT
NOTE
• If the remote control is not going to be used for an extended
period of time, remove the batteries to prevent possible electrolyte
leakage.
• The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor (located under the display window) is exposed to intense
light, such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
8
ENGLISH
R6 (size AA)
6-0,+10,C
i/k

BEFORE OPERATION

zOPEN/
CLOSE
ILLUMINATION
POWER
TUNER/BAND,
VIDEO, AUX,
DVD/CD
PHONES
AUDIO IN,
VIDEO IN
TO TURN THE POWER ON
Press one of the following buttons:
POWER on the main unit or on the remote control
TUNER/BAND:
The unit is turned on and tuned in to the previously received radio
station.
DVD/CD:
The unit is turned on and the loaded disc (CD, DVD* or VCD)
begins to play.
* If "Disc Resume" in the setup menu is set to ON (see "DISC
RESUME", page 47) and the unit is turned off while "RESUME"
is displayed on the display, DVD play will not start.
zOPEN/CLOSE:
The unit is turned on and the disc door opens.
Pressing VIDEO or AUX also turns the unit on.
To turn the power off
Press POWER.
SELECTING A FUNCTION
This unit is equipped with a disc player (to play DVDs, CDs and
VCDs) and a radio as internal sound sources. In addition, this unit
can play input from external equipment via the AUDIO IN and
VIDEO IN jacks on the front side of the unit, and the AUX IN jacks
on the rear of the unit.
To play the desired sound source, you need to select it as the
active function first.
To select a function
Press the appropriate function button on the main unit (TUNER/
BAND, VIDEO, AUX or DVD/CD), or press FUNCTION repeatedly
on the remote control.
NOTE
When you switch to the TUNER function from the DVD/CD function,
it may take up to 10 seconds before the sound actually switches
to the tuner.
FUNCTION
POWER