Remote Control; Before Operation - Aiwa NSX-AJ80 Mode D'emploi

REMOTE CONTROL

Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
To use SHIFT on the remote control
Buttons 1 have two different functions. One of these functions
is indicated on the button, and the other on the plate above the
button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the button
while pressing SHIFT.
To use FUNCTION on the remote control
FUNCTION substitutes for the function buttons (TAPE/DECK
1/2, TUNER/BAND, VIDEO/AUX, CD, MD) on the main unit.
Each time FUNCTION is pressed, the next function is selected
cyclically. When tapes are inserted in both decks, each deck is
selected with FUNCTION.
c/d PRESET on the remote control
The function is the same as that of d on the main unit.
• If the remote control is not going to be used for an extended
period of time, remove the batteries to prevent possible
electrolyte leakage.
• The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
6
ENGLISH

BEFORE OPERATION

To turn the power on
Press one of the function buttons (TAPE/DECK 1/2, TUNER/
BAND, VIDEO/AUX, CD, MD). Playback of the inserted disc or
tape begins, or the previously tuned station is received (Direct
Play Function).
POWER is also available.
When the power is turned on, the disc compartment may open
and close to reset the unit.
To turn the power off
Press POWER.
DEMO(Demonstration)
When the AC cord is plugged into an AC outlet for the first time
after purchase, the DEMO will begin in the display. When the
power is turned on, the DEMO will end. When the power is turned
off, the DEMO will begin again.
When the clock is set, the DEMO will not begin even if the power
is turned off.
To deactivate or activate DEMO
Press CLOCK, and clock is displayed in place of the DEMO.
Press DEMO to activate.
(For more about the DEMO, see page 25)
SETTING POWER ECONOMIZING MODE
When you set power economizing mode to "ECO ON" or "ECO
AUTO", the unit reduces power consumption by conducting four
ECO operations as follows.
ECO ON
• The unit (all the illumination of the display and the buttons)
blacks out when the power is turned off. Only the red indicator
lights up.
• If DIMMER (1-3) is selected, the illumination of the display and
the buttons brighten for 10 seconds only when you press a
button or turn VOLUME or MULTI JOG.
• The display dimmer mode is set to the dimmest, the button
illumination lights off, and the volume is set to the minimum (0)
when the unit turns on by timer recording.
ECO AUTO
• In addition to the three operations of ECO ON, the unit
automatically turns itself off if you do not operate it and the
sound source is mute for 10 minutes.
ECO OFF
The power economizing mode does not function.