Altec Lansing M202 Guide D'utilisation page 17

Symptom Possible Problem
Volume level is set too high.
Sound source is distorted.
Sound is distorted
Battery is weak.
Full-featured
remote
Full-featured remote is not pointed toward the
doesn't work
speaker system.
No sound from Volume on the device is set too low.
the AUX device,
Source selector is not set to AUX.
such as an MP3
player or CD
player connected
to the AUX jack
The speaker Static electricity, momentary interruption of power or
system exhibits abnormal operating conditions may be responsible.
erratic or
unexpected
behavior; controls
do not function
Solution
Decrease the volume.
If the iPhone or iPod original sound source (sound file) is of poor quality,
distortion and noise are easily noticed with high-power speakers. Try a
different audio source such as a music CD.
Replace current battery with a new battery.
Point the full-featured remote toward the Altec Lansing speaker system and
move within 10 feet of the unit.
Increase the volume on the device to approximately ¾ full volume.
Set source selector to AUX.
1. Disconnect the AC adapter cable plug from the speaker system's jack.
2. Wait 20–30 seconds.
3. Reconnect the AC adapter cable plug to the speaker system's jack.
Troubleshooting
15