Milk Flow Adjustment (Temperature Regulation); Air Adjustment For Easycream (Optional) - Nuova Simonelli TALENTO Notice D'instructions

5.3 MILK FLOW
ADJUSTMENT
(Temperature
Regulation)
- C°
NOTE: The procedure is possible also with the
appliance on.
To adjust both the flow and the temperature of the
milk delivery, turn the adjusting tap as follows:
Turn the milk suction tap CLOCKWISE/
COUNTERCLOCKWISE
DECREASE the milk suction and then
DECREASE/INCREASE the temperature.
Turn the tap until the milk reaches the desired
temperature.
42
+C°
Fig. 21
to INCREASE/
5.4 AIR ADJUSTMENT FOR
EASYCREAM (optional)
NOTE: This operation can also be performed with
the machine switched on.
To change the amount of air injected into the
Easycream and therefore, the amount of foam, use
the special adjustment screw as shown in the figure
to increase/reduce the air to the Easycream.
After setting the amount of foam for the milk foamer,
it is possible to install the adjustment knob (A) by
inserting it in the centre of the slot. To fix the knob
in place, tighten the grub screw (B) inside the door.
EN
Fig. 22
A
B
Fig. 23