Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
DISPLAY
WASHING CYCLE
The set number of
IS NEEDED
cycles programmed
before washing, has
been exceeded.
AUTOWASHING ALARM
UPPER PISTON
During the group
MOTOR
handling
GROUP ALARM
the upper piston
exceeded
mum set time by
10 seconds before
XXXXXX
GROUP ALARM
recognizing motor
pickup.
HEATER FILLING
The heater filling
ALARM
stage has exceed-
ed the 3 minute
maximum
the probe level is
FILLING ALARM
uncovered.
TURBINE ALARM
The volume coun-
ter will not send
For alarm found
any impulses to the
the display control
control unit for 5
unit alternates with
seconds.
the message about
drink under way
with the error mes-
sage
associated
with this function.
Eg:
DOSING ERROR
CAUSE
EFFECT
The message will
appear
display
machine will contin-
ue to deliver drinks.
The control unit will
phase,
halt whatever cycle
is on by turning off
maxi-
both the movement
actuator and those
for drink delivery;
the operator will not
be able to make
selections on the
keyboard.
The machine will
stop.
time;
The delivery will
continue for up to
60 seconds or for
as long as any of
the coffee based
drink
pressed.
SOLUTION
Do
a
on
the
cycle (see para-
but
the
graph WASHING
THE
DELIVERY
UNIT AND MILK
FOAMER).
Open and close the
machine door.
Open and close the
machine door.
The control unit will
repeat the machine
starting up proce-
keys
are
dure.
NOTE
washing
If the alarm reapp
ears after the sec-
ond time of taying,
call the Service
Technician.
If the alarm reapp
ears after the sec-
ond time of taying,
call the Service
Technician.
In case the alarm
persists,
machine can be
used as a manual
appliance.
Press the select-
ed key to start the
dosing;
Once the desired
dose has been
delivered in the
cup,
press
same key to halt
the dose being
delivered.
Call the Service
Technician.
the
the
57
Publicité
Table des Matières
