Nuova Simonelli TALENTO Notice D'instructions page 49

EN
2.10 CLEARING (Total wash cycles)
Press ENTER to enter the sub menu: all of
the beverage keys (1-10) will start to flash and the
display will read
CLEANING
N. 000000056
Press and hold down ENTER
to read the absolute total:
CLEANING
ABSOLUTE TOT
N. 00000056
Press RESET to quit the submenu.
Press RESET to quit the submenu.
3. PROG DOSES (Dose programming)
Pressing ENTER
sub menu and then to use the
to select the key to be programmed. The numbers,
from 1 to 10 are shown in fig. 24:
1
2
3
4
5
for 10 seconds
it is possible to access the
keys
6
7
8
9
10
Fig. 24
Press the ENTER
ming mode for the functions for the single key, fol-
lowed by ENTER
mode for the cycle functions.
GRIND TIME R (Grinding Time right grinder):
It is possible to set the grinding time in seconds and
therefore, the amount of ground coffee used.
Pressing the ENTER
access the
which serve to increase/decrease the grinding time
to a maximum of 0.5 sec.
Pressing ENTER
GRIND TIME L (Grinding Time left grinder):
It is possible to set the grinding time in seconds and
therefore, the amount of ground coffee used.
Pressing the ENTER
access the
which serve to increase/decrease the grinding time
to a maximum of 0.5 sec.
Pressing ENTER
GRIND SEL (Selects Default Grinder):
It is possible to read the default grinder (left LH or
right RH).
Pressing the ENTER
open the submenu.
Press the RESET
VOLUME CC. (Water Volume):
It is possible to set the volume of the water for the
coffee in cc.
Pressing ENTER
sub menu; the
increase/reduce water volume.
Press ENTER to confirm settings.
key to enter the program-
to enter the programming
key it is possible to
keys in the submenu,
to confirm settings.
key it is possible to
keys in the submenu,
to confirm settings.
key, it is possible to
key to exit the setting.
it is possible to enter the
keys are used to
47