Cleaning And Maintenance; Stopping The Machine; Cleaning The Outside Of The Machine; Cleaning The Stainless Coffee-Holders - Nuova Simonelli Appia Mode D'emploi

8.

CLEANING AND MAINTENANCE

During maintenance/repairs, the parts used
must be able to guarantee compliance with the
safety and hygiene requirements envisaged for
the device.
Original replacement parts can offer this gua-
rantee. After repairs to/replacement of a part
that comes into contact with foods or water, it is
necessary to carry out a washing procedure or
to follow the steps indicated by the manufactu-
rer.
8.1
STOPPING THE
MACHINE
To stop the machine, press the main switch and
set it to OFF.
8.2
CLEANING THE OUTSIDE
OF THE MACHINE
The machine must be set to "O" power (switch
off and disconnector open) before any cleaning
operations are performed.
WARNING
Do not use solvents, chlorine-based pro-
ducts or abrasives.
WARNING
It is not possible to clean the machine using
water jets or standing it in water.
Cleaning the work area: remove the worktop,
lifting it up from the front and sliding it out.
Remove the water collection dish underneath
and clean everything with hot water and clean-
sers.
Cleaning the bottom: To clean all the chro-
mium-plated areas, use a soft, damp cloth.
8.3
CLEANING THE STAIN-
LESS COFFEE-HOLDERS
The stainless coffee-holders are situated under
the delivery units, as shown in figure.
Fig. 26
NOTE: To clean proceed as follows:
• Turn the screw placed in the centre of
the coffee-holder.
• Slide the coffee-holder out and check
that its holes are not obstructed but
clean.
• If obstructed, clean as described
(Paragraph "CLEANING FILTERS
AND FILTER-HOLDERS")
We recommend cleaning the coffee-
holder once a week.
8.4
CLEANING THE UNIT
WITH THE AID OF THE
BLIND FILTER
The machine is pre-set for cleaning the delivery
unit with a specific washing powder.
We recommend carrying out a washing cycle at
least once a day with special cleansers.
RISK OF INTOXICATION
Once the filter-holder has been removed,
repeat delivery operations a few times to eli-
minate any cleanser residues.
Per eseguire la procedura di lavaggio procede-
re come segue:
1) Sostituire il filtro con quello cieco del gruppo
erogatore.
2) Mettervi all'interno due cucchiai di detergen-
te specifico in polvere e immettere il portafil-
tro al gruppo.
3) Premere uno dei tasti caffè e arrestare dopo
10 sec. .
4) Ripetere l'operazione più volte.
5) Togliere i portafiltro ed effettuare alcune ero-
gazioni.
Fig. 27
8.5
CLEANING FILTERS
AND FILTER-HOLDERS
Place two spoonfuls of special cleanser in half
a litre of hot water and immerse filter and filter-
holder (without its handle) in it leaving them to
soak for at least half an hour. Then rinse abun-
dantly with running water.
CAUTION
41