Panasonic DVCPRO AJ-BS900P Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Parts and their functions
Rear panel
?
TALLY connector
This is the connector for the R tally and G tally signals. It
can be used for PM tally.
@
DC power fuse (FUSE)
This fuse is for the AJ-BS900P's DC power supply. Use a
dedicated DC fuse (400V 15A) which can withstand inrush.
A
4 : 2 : 2 connectors
These connectors are for component serial digital output.
They are activated if the AJ-YA901P option board is
installed. One component may be connected to each
output BNC connector. The output signals comply with the
SMPTE259M-C standard.
B
Y/G, PB/B, and PB/R connectors
These output connectors are for component signals or
RGB signals. Use the switch on the BS DIGITAL board to
select the system. For details, refer to "Switches" (pages
18).
C
Video output connectors
These are output connectors for component video signals.
D
PIX output connector
This is the output connector for the picture monitor signal.
Signal switching is performed using the PIX SEL switch.
E
WFM output connector
This is the output connector for the waveform monitor
signal. Signal switching is performed using the MONI SEL
switch.
F
OP1 connector
This connector is not used on the current version of the AJ-
BS900P.
G
OP2 connector
This connector is not used on the current version of the AJ-
BS900P.
- 8 -

Publicité

Table des Matières
loading

Table des Matières