Setting The Microswitch Position; Switching The Controller - Panasonic DVCPRO AJ-BS900P Mode D'emploi

Switches
Setting the board switch positions
SW2-1: Y/G, PB/B, PR/R selector switch
ON: Y, PB, PR output
OFF:G, B, R output
<Note>
When selecting the positions of the above switches, make sure that you do not change the positions of the other switches indicated
with the broken lines by touching them by mistake.

Setting the microswitch position

The front cover must be removed in order to select the dynamic
microphone or carbon microphone setting.
Refer to the diagram below to perform the selection.
<Note>
The unit was shipped from the factory with the dynamic microphone
selected for this setting.

Switching the controller

Select the front panel or controller connected to the OP3 connector for
the controller. Refer to the figure at the bottom right when making this
selection.
<Note>
Turn off the unit's power before making the selection.
CAUTIONS:
These servicing instructions are for use by qualified
service personnel only. To reduce the risk of electric
shock do not perform any servicing other than that
contained in the operating instructions unless you are
qualified to do so.
SW2
8
7
6
5
4
3
2
1
ON OFF
BS DIGITAL board
SW2-6: Color bar setting selector switch
ON: SNG color bar
OFF:SMPTE/FULL color bar
Dynamic
microphone
- 18 -
Carbon
microphone
PUSH
RCOP
Front panel