Contents
Features .................................................................................... 2
Checkpoints for system connections ......................................... 2
Front panel..................................................................................................3
Rear panel ..................................................................................................7
Switches .................................................................................. 16
Removing the boards................................................................................16
Specifications .......................................................................... 19
Features
The unit has the following features.
≥ It enables high picture quality transmission by means of non-compressed wide-band 360 Mbps serial component signals.
≥ It uses a tri-axial cable.
≥ It enables a DVCPRO camera recorder to be operated as a system camera.
≥ It enables transmission up to 2000 meters when three AJ-RP900P Repeaters are used. (*1)
≥ It enables the transmission of the signals of two audio channels.
≥ It enables RET 1CH and PROMPT 1CH transmission.
≥ It has a compact size equivalent to one-half of a rack unit.
≥ It can also be operated using DC power.
≥ It can perform the VTR operations of the camera recorder. (*2)
*1
The power supply is subject to limitations. Consult your dealer when configuring the system.
*2
During VTR playback operations (PLAY, FF or REW), the BS output pictures and sound will be switched to the playback mode. Under the current version,
however, the images of the camera will be viewed since the playback board has not been installed. As far as the audio signals are concerned, the signals
on the tape will be output from BS during VTR playback operations (PLAY, FF or REW): this means that care should be taken when the camera recorder's
microphone is used.
Checkpoints for system connections
Bear in mind the following checkpoints when connecting the camera recorder to the unit's system.
1 Remember that if the power is turned on or off while the camera's menu is open, the menu will appear on the viewfinder.
2 When the unit is connected, the RET SW operations will be canceled on the camera's REC/PB/RET menu.
3 When connecting the unit to a camera recorder, do not supply the signals to the GENLOCK connector on the camera.
4 The triax and ECU (extension control unit) cannot be used at the same time for the camera recorder.
5 When the triax is connected, some of the settings (such as GAIN, CAM-BAR SW, WHITE BAL and SHUTTER) selected by
the switches on the camera recorder will not take effect.
6 When the triax is connected, the composite video signals (CAM OUT, VIDEO OUT) of the camera recorder will be non-
standard signals.
- 2 -