HQ Power VDPLPS3612 Serie Notice D'emploi page 5

7. Operation
•
Set the desired mode using the mode button [1A]. The mode is indicated in the display (refer to the table
below).
•
Change the setting with the UP [1B] or DOWN [1C] buttons.
display
sound controlled
green (G)
R + G + B
R +G + B flash
7 colour change
7 colour flash
7 colour fade
•
When using DMX mode (
•
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. controlled devices need a digital start address so that the correct device responds to the signals.
This digital start address is the channel number from which the device starts to "listen" to the DMX This digital start address is the channel number from which the device starts to "listen" to the DMX
controller. The same starting address can be used for a whole group of devices or an individual address can
be set for every device.
•
When all devices have the same address, all the units will "listen" to the control signal on one particular When all devices have the same address, all the units will "listen" to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you
set individual addresses, each device will "listen" to a separate channel number. Changing the settings of one set individual addresses, each device will "listen" to a separate channel number. Changing the settings of one
channel will only affect the device in question.
•
In case of the 5-channel VDPLPS3612X, you will have to set the start address of the first unit to 1
(CH1~5), the second unit to 6 (1 + 5) (CH6~10), the third to 11 (6 + 5) (CH11~1
CH1
function
(mode)
000 ~ 025 Black out
R, G, B
026 ~ 050
051 ~ 100
7 colour change
101 ~ 150
7 colour fade
151 ~ 200
sound controlled
201 ~ 240
241 ~ 255 full R, G, B
•
To use slave mode, first connect the devices as described in §6b.
•
On all slave devices set the mode to
03.03.2011
mode
DMX
red (R)
blue (B)
R + G
R + B
B + G
black out
DMX address
), first set the DMX address.
can be used for a whole group of devices or an individual address can
CH2
(speed)
000 ~ 255
dimmer
000 ~ 255
flash
slow ~ fast
000 ~ 255
slow ~ fast
000 ~ 255
slow ~ fast
000 ~ 255
slow ~ fast
VDPLPS3612x
. The mode is indicated in the display (refer to the table
setting
see table below
sensitivity
brightness
all LEDs off
speed
channel will affect all devices simultaneously. If you
DMX mode ( )
CH3
(red)
- -
000 ~ 255
000 ~ 255
brightness
-
-
-
- -
.
5
from
-
max. max.
off
-
fast fast
ss of the first unit to 1
11~15), and so on.
CH4 CH4
(green) (green)
-
000 ~ 255 000 ~ 255
000 ~ 255 000 ~ 255
brightness brightness
-
-
-
-
to
-
min.
max.
-
slow
CH5
(blue)
-
000 ~ 255
000 ~ 255
brightness
-
-
-
-
©Velleman nv