Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Choke shutter open (j)
4
if the engine is warm, i.e. if it has
–
been running for about one minute.
Hold and start your saw as
N
described.
When engine begins to fire
4
Move the choke lever (4) to the
N
open position (j).
Hold and start your saw as
N
described.
28
As soon as the engine runs
3
2
Press down trigger lockout and the
N
blip the throttle trigger (2) – the
Master Control lever (3) moves to
the run position (F) and the engine
settles down to idling speed.
Pull the hand guard toward the
N
handlebar to disengage the chain
brake.
NOTICE
Always disengage chain brake before
accelerating the engine. High revs with
the chain brake engaged (chain locked)
will quickly damage the clutch and chain
brake.
After a cold start, warm up the
N
engine at varying speeds – your saw
is ready for operation.
At very low outside temperatures
If idling behavior is erratic or
acceleration is poor:
Readjust carburetor if necessary,
N
see "Adjusting the Carburetor".
If your saw is very cold (frost or ice
N
on machine), start the engine and
keep it at a high idle speed (with
chain brake disengaged) until it
reaches normal operating
temperature.
Stopping the engine
Move Master Control lever to
N
Stop 0.
If the engine does not start
If you did not move the Master Control
lever from the choke closed
position (l) to the choke open
position (j) quickly enough after the
engine began to fire, the engine is
probably flooded.
Move Master Control lever to
N
Stop 0.
Remove the spark plug – see
N
"Spark Plug".
MS 193 C
Publicité
Table des Matières
