Krick RoMarin FLB 1 Mode D'emploi page 75

Glue GPS 8.30 to the roof.
Glue together the rope baskets from the base 8.40 and the basket 8.39. Glue the rope baskets to the foredeck
and the deck.
8.39
8.32 3*
8.40
Fig.: Rope basket Fig.: Gooseneck ventilator
Glue the gooseneck ventilators together from 3 parts 8.32 each, sand them and glue them to the deck in the
stern area.
Cut the brass strip into 4 equal parts. Bend the holders 8.33 for the lifebelts according to the drawing. Glue the
holders to the railing of the superstructure and the stern rail.
Fig.: Life ring holder bent
Assemble the rear ladder from the side bars part 8.36, the crossbars part 8.37, the shaft 8.38 and the brackets
part 2.28. Glue 2 side bars 8.36 on each other. Push the bars through the holes to align them. Push in the
bars. Align the ladder and glue the bars in place.
Push the axle through one rail, push the two bearings part 2.28 onto the axle and push the axle through the
other rail. Glue the axle in the rails, making sure that the axle does not stick to the bearings. Now insert the
bearings into the recesses of the rear platform and glue them.
Glue the hose connections 8.42 to the previously painted flange plate. Glue the plate to the superstructure
between the stairs and the companionway.
8.44
8.43
8.45-8.50
Fig.: Fittings on the hull
Status 25. August 2022 33 © Krick Modelltechnik