Krick RoMarin FLB 1 Mode D'emploi page 58

Caution: Only separate the combined window frames from the laser panels.
Fig.: Windows for marking the cut-outs on the superstructure
Centre of superstructure
Cut-out door window
5 mm
Fig.: Marking the window cut-outs
Mark the centre of the superstructure on the roof.
Tape the window groups to the superstructure and mark the cut-outs for the windows.
Remove the window groups from the superstructure again and lay them on their side until painting. If the
window frames are to be painted a different colour, e.g. aluminium, paint the frames first and attach them after
painting of the superstructure.
Drill small holes in the corners and cut out the window openings. Then smooth the edges with sandpaper.
Abb.: Fensterrahmen montiert
Status 25. August 2022 16 © Krick Modelltechnik