Krick RoMarin FLB 1 Mode D'emploi page 66

6.8
6.7
6.13-6.14
Fig.: Lamp holder and signal lamps
Push part 6.4 through the hole in the mast and align it centrally. The notch must be open to the rear. Glue into
the mast.
Cut the lamp holder 6.6 from 2mm brass wire and bend it according to the drawing. Glue or solder the lamp
holder 6.6 to the frame 6.5. Insert it into the centre part 6.4, align it centrally and glue.
Bend parts 6.9 for the antenna. Cut part 6.10 to length and glue or solder them all together.
Fig.: Mast complete
You can pull the bulbs partly through the yard, inwards into the mast and lead them down in the mast. Where
the cables cannot be pushed through tubes, they must be led outside to the cable channel and then down in
the channel.
When all cables have been pulled in, glue on the cover 6.16 and sand the edges.
Status 25. August 2022
6.6
6.5
6.4
notch
6.15
24
6.9
6.10
Fig.: Antenna
© Krick Modelltechnik