Turn the counter nut 1.13 up to the thread run-out on the ship's shaft 1.11.
Check that the stern tube (1.10) protrudes 8 mm to the rear. Make corrections by moving the coupling hose
and shifting the ship's shaft and stern tube.
Glue the stern tube tightly in the shaft sleeve with Stabilit-Express. To do this, turn the sterntube After applying
the glue, turn the sterntube to spread the Stabilit-Express.
Glue the RC plate and motor bulkhead in the hull.
Glue the supporting bulkhead 1.15 to the hull
Rudder and servo mount
No.
Description
2.1
Servo base plate
2.2
Side part
2.3
Servo frame
2.4
Self-tapping screw
2.5
Rudder
2.6
Washer
2.7
O-Ring
2.8
Rudder tube
Assemble the servo mount from parts 2.1 - 2.3 and glue the parts together.
Test-fix the finished bracket to the base plate with self-tapping screws 2.4.
Grind or file a surface on the rudder shaft for the grub screw of the rudder lever.
Attention: pay attention to the correct side (at the front in the direction of travel).
Slide on washer 2.7, O-ring 2.8 and rudder tube 2.9. Place the unit into the align
and fix rudder tube with superglue.
Glue the rudder tube in the hull and to the bottom plate with Stabilit-Express.
Status 25. August 2022
2.3
2.1
Laser part
Laser part
Laser part
Ready made
Ready made
Ready made
Ready made
Brass
2.2
Fig.: Servo mount and rudder
6
Dimensions
Qty
Laserpl. 1,5
1
Laserpl. 1,5
2
Laserpl. 1,5
1
D 2,2 * 6,5
2
1
D 3,2 * 7
1
D 2,7 * 1,5
1
D 4 * 0,4 * 55
1
2.8
2.7
2.6
2.5
© Krick Modelltechnik