Krick RoMarin FLB 1 Mode D'emploi page 50

Installation of the anchor case
No. Description
2.18 Anchor case
2.19 Anchor case side
2.20 Anchor case top
2.21 Downpipe
2.22 Chain tube
2.23 Step
2.24 Platform
2.25 Grille
2.26 Underlay
2.27 Frame
2.28 Ladder bearing
2.29 Pin
2.19
2.18
Abb.: Ankertasche zusammensetzen
18
Fig.: Anchor case installation
Next, make the rear platform from parts 2.24 - 2.27.
Glue the grille 2.25 onto the platform 2.24. Be careful to glue only on the edge and not on the bars. Glue the
frame 2.27 on top. Glue part 2.26 at the bottom. Cut off the overhanging edge of 2.25. Sand the trailing edge
at a slight angle according to the taper of the fuselage.
Now glue the pins 2.29 into the 5 recesses.
Status 25. August 2022
2.20
90
Laser part
Laser part
Laser part
Plastic tube
Plastic tube
Laser part
Laser part
Ready made
Laser part
Laser part
Laser part
Brass wire
Glue together the anchor case from parts 2.18 -
2.20.
From the nose of the hull 90 mm and 18 mm from the
bottom edge of the rubbing strake, mark and cut out the
recess for the anchor pocket 25 mm * 27 mm.
Insert the anchor case from behind so that the protruding
side parts 2.19 hook into the bottom. Fix the anchor pocket
with superglue and grout with Stabilit Express.
8
Dimensions Qty
Laserpl. 1,5 1
Laserpl. 1,5 2
Laserpl. 1,5 1
D 6 * 60 mm 1
D 5 * 30 1
Laserpl. 1,5 2
Laserpl. 1,5 1
1
Laserpl.1 1
Laserpl.1 1
Laserpl. 1,5 2
D 1,5 * 15 5
© Krick Modelltechnik