Krick RoMarin FLB 1 Mode D'emploi page 65

Step 6, the Mast
No. Description
6.1 Mast, inside
6.2 Mast, Centre
6.3 Mast, outside
6.4 Yard, centre
6.5 Yard
6.6 Lamp holder
6.7 Lamp base, 3 mm
6.8 Lamp base, 2 mm
6.9 Antenna
6.10 Antenna
6.11 Mast base
6.12 Foot plate
6.13 Allround light
6.14 Bulb
6.15 Top lamp, with bulb
6.16 Cover
From parts 6.1 - 6.3, glue the mast together. If the mast is equipped with lighting, do not glue the back of the
mast until the cables have been pulled in and then sand it.
6.2
6.1
Fig.: Mast assembly
Round off the front edges of the mast and grind the mast thinner towards the top, taper it.
Glue the mast foot together from parts 6.11 and 6.12. Place the mast in the mast foot and drill through it.
Now make the yard with the lamp holders. Notch the centre part 6.4 in the middle with a round file so that
cables can be pulled through. Also notch part 6.5 on the yard according to the drawing in order to solder or
glue the lamp holder 6.7 there.
Status 25. August 2022
6.16
6.3
Dimensions
Laser part Laserpl. 1,5
Laser part Laserpl. 1
Laser part Laserpl. 1
Brass tube D 4 * 25 mm
Brass tube D 3 * 40 mm
Brass wire D 2 * 70 mm
Laser part Laserpl. 1
Laser part Laserpl. 1
Brass wire D 1 * 30 mm
Brass wire D 1 * 90 mm
Laser part Laserpl. 1,5
Laser part Laserpl. 1,5
Ready made Plastic
Ready made D 2,3
Ready made D 3
Laser part Laserpl.1
6.1 – 6.3
Round edges
23
Qty.
2
2
2
1
2
2
2
4
3
1
2
1
6 BS
6 BS
1 BS
1
6.16
6.11
6.12
Fig.: Mast base
© Krick Modelltechnik