Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
INSTALLATION INSTRUCTIONS
KIT CONTENTS:
1. Rear Bumper Protection Film (1).
2. Installation Instructions (1).
3. Squeegee (1).
2. Installation Instructions
TOOLS REQUIRED:
MEANING OF CHARACTERS:
Denotes warnings that may lead to
serious physical injury or vehicle
damage.
Denotes cautions to be taken to avoid
physical injury or electronic component
damage.
Denotes cautions to be taken to avoid
vehicle and component damage.
DESCRIPTION
Rear Bumper Protection Film
PART NUMBER: E771SCA700
DESCRIPTION:
BRZ Rear Bumper Protection Film.
1. Rear Bumper Protection Film
Soft lint-free
Microfiber Cloth
Denotes quality processes to be
checked prior to moving to the next
step.
Denotes specific tools that are
necessary to complete the step.
Denotes instructional steps
necessary to complete the
process.
ISSUE
DATE
00
02/22/12
3. Squeegee
Application
Solution
Denotes safety equipment required to be used
such as a mask, goggles, rubber gloves, and
hearing protection.
Mask
Rubber Gloves
SUBARU OF AMERICA
Goggles
Hearing Protection
PAGE
1/08
Publicité
Table des Matières
Manuels Connexes pour Subaru E771SCA700
Sommaire des Matières pour Subaru E771SCA700
- Page 1 PART NUMBER: E771SCA700 DESCRIPTION: INSTALLATION INSTRUCTIONS BRZ Rear Bumper Protection Film. KIT CONTENTS: 1. Rear Bumper Protection Film (1). 2. Installation Instructions (1). 3. Squeegee (1). 1. Rear Bumper Protection Film 2. Installation Instructions 3. Squeegee TOOLS REQUIRED: Soft lint-free...
-
Page 2: Preparation - Before Installation
Before removing liner, locate the two notches in the applique Spray bumper surface with Application Solution. directly under the notches in bumper and align as shown above. DESCRIPTION ISSUE DATE PAGE SUBARU OF AMERICA Rear Bumper Protection Film 02/22/12 2/08... - Page 3 Remove top protective covering CAREFULLY 180° against three or four back and forth strokes in the direction shown. itself. Re-squeegee any areas or edges that may have lifted during premask removal. DESCRIPTION ISSUE DATE PAGE SUBARU OF AMERICA Rear Bumper Protection Film 02/22/12 3/08...
-
Page 4: Care And Cleaning
85°F and 100°F. 90° angle. Use Isopropyl alcohol and a soft, lint free cloth to clean any remaining adhesive on the fascia. DESCRIPTION ISSUE DATE PAGE SUBARU OF AMERICA Rear Bumper Protection Film 02/22/12 4/08... -
Page 5: Contenu De La Trousse
NUMÉRO DE PIÈCE : E771SCA700 DESCRIPTION: INSTRUCTIONS D’INSTALLATION Pellicule protectrice pour le pare–chocs arrière BRZ. CONTENU DE LA TROUSSE : 1. Pellicule protectrice pour le pare–chocs arrière (1). 2. Instructions d’installation (1). 3. Raclette à lame de caoutchouc (1). 1. Pellicule protectrice pour le pare–chocs arrière 2. -
Page 6: Préparation Avant L'installation
Avant de retirer le revêtement, repérer les deux encoches de la Vaporiser la solution pour l’application sur le pare–chocs. pellicule et celles du pare–chocs et faites–les correspondre comme indiqué ci–dessus. ISSUE DATE PAGE DESCRIPTION SUBARU OF AMERICA 02/22/12 6/08 Pellicule protectrice pour le pare–chocs arrière BRZ... - Page 7 180 °. Repasser la raclette sur les surfaces qui se dans le sens indiqué dans l’image. sont soulevées lors du retrait de la pellicule superficielle. ISSUE DATE PAGE DESCRIPTION SUBARU OF AMERICA 02/22/12 7/08 Pellicule protectrice pour le pare–chocs arrière BRZ...
-
Page 8: Nettoyage Et Entretien
85 ºF et 100 ºF. isopropylique et un linge doux et non pelucheux pour essuyer l'adhésif qui pourrait être demeuré sur le bouclier. ISSUE DATE PAGE DESCRIPTION SUBARU OF AMERICA 02/22/12 8/08 Pellicule protectrice pour le pare–chocs arrière BRZ...