Operation; Selecting The Signal Source (Video); Configuring The Projection Settings; Manually Changing The Volume - Renkforce RF-PJ-300 Notice D'emploi

13. Operation

a) Selecting the signal source (video)
Verify that you have connected the correct signal cable for the desired video signal
source.
Select the input signal to be displayed by the projector. Proceed as follows:
• Press the signal selection button
the remote control to display the selection menu of the input signal sources.
• Use the buttons in the menu to navigate through the menu options for the video signal
sources. You can choose between VGA, HDMI, AV, USB and microSD.
• Use the buttons to select the desired source signal.
b) Configuring the projection settings
• Turn the Focus selection wheel (2) to adjust the image setting.
• Turn the Keystone selection wheel (3) to adjust the keystone correction.
c) Manually changing the volume
• Press the Volume + (plus) button (8) or - (minus) button (14) to increase or decrease the
volume.
These buttons can also be used in the menu as a selection key and for setting the
parameters.
• Press the mute button on the remote control to turn the sound off. Press again to switch
the sound back on.
d) Playing video content
• If you have selected the memory card or USB as the signal source, use the
select the desired file type (photo, music, film text) and confirm with the OK button.
• Use the and
selection by pressing the OK button.
• Press the button on the remote control to play the selected media content.
(11) on the device or the signal selection button
buttons to select the location of the file you want to open. Confirm your
on
buttons to
21