Connected Devices; Led Light; Electrical Safety - Renkforce RF-PJ-300 Notice D'emploi

• Handle the product carefully. Jolts, impacts or a fall even from a low height may
damage the product.
• Consult a technician if you are not sure how to use or connect the product, or if
you have concerns about safety.
• Maintenance, modifications and repairs may only be carried out by a technician
or a specialist repair centre.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
b) Connected devices
Always observe the safety information and operating instructions of any other
devices which are connected to the product.
c) LED light
• Do not look directly into the light of the lens while the projector is in use, as this
may cause eye damage.
• Attention, LED light:
- Do not look directly at the LED light!
- Do not look into the beam directly or with optical instruments!
d) Electrical safety
• This device was constructed according to protection class II. Only connect the
mains plug to a standard mains socket (100 - 240 V/AC, 50 Hz) connected to
the public grid.
• Never pour any liquids over electrical devices or put objects filled with liquid next
to the device. If liquid or an object does get inside the device, power down the
respective socket (e.g. switch off the circuit breaker), and then remove the mains
plug from the mains socket. Discontinue use and take the product to a specialist
repair centre.
• Never use the product immediately after it has been taken from a cold room into
to a warm one. This may cause condensation to form, which can destroy the
product. Allow the product to reach room temperature before connecting it and
putting it into use. This may take several hours.
• The mains socket must be located near to the device and be easily accessible.
7