Setup; Turning The Projector On/Off - Renkforce RF-PJ-300 Notice D'emploi

Tips
1
• Make sure that there is an unobstructed line of sight between the remote control and the
infrared sensor. The signal must not be blocked by opaque objects.
• To ensure unobstructed reception, point the remote control towards the rear left of the device
or directly at the infrared sensor.
• To prevent damage to the remote control, do not store it in places where it may be exposed
to high temperatures or moisture.

12. Setup

The lens cap must be removed before the image can be projected. Replace the lens
cap when you have finished using the projector.
a) Turning the projector on/off
• Wait for approx. 3 seconds after connecting the device to the mains voltage. The LED will
turn red.
• Press the on/off
• Press the on/off
• You can also switch off the projector via the on/off
• The LED will turn red to indicate that the projector is in standby mode.
Before disconnecting the power plug, make sure that the projector fan has turned
off. If this is not the case, this indicates that the device has not yet cooled down
sufficiently. Never unplug the mains plug from the mains socket before the fan has
switched off, as the device could still be too hot without further cooling. This excess
heat will affect the lifespan of the device.
20
button (6) to switch the device on. The LED will turn green.
button to switch the device off.
button on the remote control.