Remote Control; Inserting/Changing The Batteries; Using The Remote Control - Renkforce RF-PJ-300 Notice D'emploi

11. Remote control

a) Inserting/changing the batteries
Before first use, insert two new 1.5 V batteries into the remote control.
• Open the battery compartment cover on the back of the remote control.
• Insert two AAA batteries (not included) with correct polarity into the battery compartment
(observe the plus/+ and minus/- markings).
• Replace the battery compartment cover.
Replace the batteries when the range of the remote control decreases noticeably.
• To change the batteries, remove the battery compartment cover from the back of the remote
control.
• Remove the used batteries before inserting the new batteries. Proceed as described above.
b) Using the remote control
On/off button
Forwards button
OK button
ESC button
Volume -
• Direct the remote control at the infra-red sensor on the product. The remote control has
a range of approx. 6 m at an angle of inclination of up to 30°.
• You can also configure the settings using the buttons on the projector.
Mute button
Play/pause button
Back button
Menu button
Signal selection button
Volume +
19