Product Description; Specifications - Shindaiwa HomePro 195 Série Manuel D'utilisation

Product Description

1. Gearcase
2. Outer Tube
3. Handle
4. Grip
5. Cutting Attachment Shield
6. Cylinder Cover
7. Throttle Lever
8. Fuel Tank
9. Ignition Switch
10. Air Cleaner
11. Spark Plug
5
1
Figure 4
Specifications
Engine Model ....................... S195
Engine Type ......................... 2-cycle, vertical-cylinder,
Dry weight, T195s
(excluding cutting
attachment) ........................... 4.1 kg/9.0 lb
Dry weight, F195s
(excluding cutting
attachment) ........................... 4.9 kg/9.51 lbs
Bore x Stroke ........................ 30 mm x 28 mm/1.18" x 1.10"
Displacement ........................ 19.8 cc/1.21 cu. in.
Maximum Power
Output ................................... 0.8 hp/0.6 kW @ 7500 RPM (min
Transmission Type .............. Automatic, centrifugal
Fuel/Oil Ratio ....................... 50:1 with Shindaiwa Premium
Specifications are subject to change without notice.
Inspect
The F195s and T195s come fully assem-
bled with the exception of the cutting
attachment shield and cutting attach-
ment. Before completing the assembly,
carefully inspect the unit and all compo-
nents for any damage and make sure all
components are there.
Prior to Assembly
Before assembling, make sure you have
all the components required for a com-
plete unit:
9
3
9
2
3
5
air-cooled
clutch with bevel gear
2-cycle Engine Oil
 Engine and shaft assembly.
 Cutting attachment shield.
 Cutting attachment.
 Kit containing cutting attachment
shield mounting bracket and hard-
ware, this owner/operator's manual
and tool kit for routine maintenance.
Tool kits vary by model and may in-
clude a hex wrench set, a spark plug/
screwdriver combination wrench, and
a spanner.
T195s
11
6
10
4
8
11
F195s
7
10
6
4
8
7
Fuel Tank Capacity .............. 400 ml/13.6 ounces
Carburetion ........................... Walbro WYA (w/primer)
Ignition System .................... Electronic
Spark Plug ............................. Champion NGK BPMR8Y
Air Cleaner ............................ Semi-wet type
Starting Method ................... Recoil starter
Stopping Method .................. Slide switch
Handle ................................... Loop type
EPA Emission
Compliance Period* ............. Category A
)
-1 * The EPA emission compliance referred to on the emission compliance
label located on the engine, indicates the number of operating hours for
which the engine has been shown to meet Federal emission require-
ments. Category C = 50 hours (Moderate), B = 125 hours (Intermedi-
ate) and A = 300 hours (Extended).
Using the illustrations in this manual as
a guide, familiarize yourself with your
unit and its various components. Un-
derstanding your unit helps ensure top
performance, long service life, and safer
operation.
WARNING!
Do not make unauthorized modifica-
tions or alterations to either of these
units or their components.
IMPORTANT!
The terms "left", "left-hand", and "LH";
"right", "right-hand", and "RH"; "front"
and "rear" refer to directions as viewed
by the operator during normal
operation.
5