Shindaiwa HomePro 195 Série Manuel D'utilisation page 12

50-Hour Maintenance
Ever y 50 hours of operation
(more frequently in dusty or dirty condi-
tions):
 Remove and clean the cylinder cover
and clean grass and dirt from the
cylinder fins.
 Use a hooked wire to extract the fuel
filter from inside the fuel tank.
See Figure 23.
CAUTION!
Make sure you do not pierce the fuel
line with the end of the hooked wire.
The line is delicate and can be dam-
aged easily.
 Remove and replace the filter ele-
ment. Before reinstalling the new
filter element, inspect the condition of
all the fuel system components (fuel
pick-up line, fuel return line, tank vent
line, tank vent, fuel cap and fuel tank).
If damage, splitting or deterioration
is noted, the unit should be removed
from service until it can be inspected
or repaired by a Shindaiwa-trained
service technician.
Shims
Clamp
Screw
Index Bolt
New Grease
Figure 24
12
Hooked
Wire
Figure 23
Gearcase Lubrication (T195s Only)
1. To perform this operation, first re-
move the gearcase and debris
shield from the outer tube as follows.
See Figure 24.
Outer Tube
4 Socket
Head Screws
Grease Plug
CAUTION!
Do not remove the D-shaped shim
washer! The shim washer prevents
damage from overtightening the tube
clamp screw.
 Remove the index bolt from the
gearcase.
 Loosen the gearcase clamp screw.
 Loosen the four socket head cap
screws that secure the cutting attach-
ment shield.
 Slide the gearcase and cutting attach-
ment shield off the tube. (Do not lose
the two shims).
Filter Element
2. Remove the filler plug and press new
grease into the gearcase until old
grease is purged from the gearcase,
which can be seen in the outer tube
cavity.
3. Clean up the excess grease and re-
install the cutting attachment shield,
two shims and the gearcase.
4 Socket
Head Screws
Old Grease
Outer Tube
Cavity