Parts Replacement/Maintenance; Air Separator Seal - Carlisle TEKNA BASECAOT Mode D'emploi

10-1
10-3
10-5
10-7
10-9
Flats on seal and gun must align.
TB-1018-R1 (2/2018)
Parts Replacement/
10-2
Maintenance

AIR SEPARATOR SEAL

REPLACEMENT
1. Remove air cap and retaining ring.
10-4
(See picture 10-1)
2. Remove fluid adjusting knob, spring, and
spring pad. (See pictures 10-2 & 10-3)
3. Remove fluid needle from gun body.
(See picture 10-4)
4. Remove fluid nozzle (using 10 mm wrench),
air separator, and seal.
(See pictures 10-5 & 10-6)
5. Remove seal from air separator.
10-6
(See picture 10-7)
6. Clean front of gun if required, using
a soft brush, as well as the air separator,
fluid nozzle, air cap, and retaining ring.
(See pictures 10-8 & 10-9)
7. Place a new air separator seal onto the front of the
gun. The flat on the seal must align with the gun's
flat. (See picture 10-10)
8. Reinstall the air separator, making sure the pin is
engaged into the hole in the gun body. Reinstall the
10-8
fluid nozzle and torque the fluid nozzle to 18–20
nm (13–15 ft-lbs). Don't over torque the fluid
nozzle. A drop or two of lubricant on the fluid nozzle
threads and air separator threads insures smooth
assembly. Reinstall the air cap and retaining ring.
9. Insert fluid needle all the way into the gun
body, seating in fluid nozzle.
(See picture 10-4)
10. Reassemble needle spring, spring pad,
and fluid adjusting knob. A drop or two
10-10
of lubricant assures smooth operation.
(See pictures 10-2 & 10-3)
11. Trigger gun fully and screw in fluid adjusting
knob until it stops. Back it off 1/2 turn and
gun will have full needle travel.
12. Trigger gun several times to verify
proper operation.
11 / 16
EN
www.carlisleft.com