Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
machine and lift the device to an upright position
so that it is supported by the front end support
legs.
Store the rowing machine in the storage position
against a wall in such a way that the front frame
cannot fall on anyone by accident.
The device is shipped with a loop and
IMPORTANT!
a hook for securing the rowing machine properly
in the storage position. Choose an appropriate
storage site for your rowing machine next to a wall
and attach the hook tightly to the wall at the right
height. Lift the rowing machine to the storage
position in front of the hook. Thread the loop
provided with the rowing machine around the
cross bar and attach the loop to the hook. Do not
climb on the rowing machine when it is in storage
position!
MAINTENANCE
•
The R60 requires very little maintenance.
Check, however, from time to time that all screws
and nuts are tight.
•
Clean the cycle with a damp cloth. Do not use
solvents.
•
Never remove the protective covers.
•
Clean the inner surfaces of the rail if necessary
so that the seat moves as smoothly and quietly as
possible. If necessary, you may improve the seat
movement by adding paraffin to the surface of the
rails.
BATTERY REPLACEMENT
Meter batteries: A warning display reports when
the batteries of the meter need to be replaced.
Turn the meter carefully outward from the front
frame so that you can remove the battery box
cover on the back of the meter. Open the battery
box cover carefully from its lower edge. Be careful
not to damage the wires. Replace the batteries (4
"C" batteries) in the battery box according to the
markings. Replace the cover.
Pull-bar battery: If the pull-bar controls cease
to respond completely, replace the battery
O W N E R ' S M A N U A L
(3V lithium cell CR2032). Open the cover of
the battery box on the back of the pull bar by
removing the attachment screw. Replace the
battery; make sure you place it in the right
direction inside the holder. Replace the cover.
MALFUNCTIONS
Despite continuous quality control, defects and
malfunctions caused by individual components
may occur in the equipment. In most cases it's
unnecessary to take the whole device in for repair,
as it's usually sufficient to replace the defective part.
If the equipment does not function properly
during use, contact your Tunturi dealer
immediately. Always give the model and serial
number of your equipment. Please state also the
nature of the problem, conditions of use and
purchase date.
If you require spare parts, always give the model,
serial number of your equipment and the spare
part number for the part you need. The spare part
list is at the back of this manual. Use only spare
parts mentioned in the spare part list.
TECHNICAL SPECIFICATIONS
Length ......................................... 200 cm
Width .......................................... 48 cm
Height .......................................... 56 cm
Weight .......................................... 46 kg
The R60 meets the requirements of the EU's
EMC Directives on electromagnetic compatibility
(89/336/EEC). This product therefore carries the
CE label.
The R60 meets EN precision and safety standards
(EN-957).
Due to our continuous policy of product
development, Tunturi reserves the right to change
specifications without notice.
The instructions must be followed carefully
NOTE!
in the assembly, use and maintenance of your
equipment. The warranty does not cover damage
due to negligence of the assembly, adjustment
and maintenance instructions described herein.
Changes or modifications not expressly approved
by Tunturi Oy Ltd will void the user's authority to
operate the equipment!
We wish you many enjoyable trainings with
your new Tunturi training partner!
G B
•
R 6 0
9
Publicité
Chapitres
Table des Matières
