Machine Operation; Tank Emptying; After Using The Machine; First Period Of Use - Nilfisk Advance Micromax 17E Instructions D'utilisation

MACHINE OPERATION

1. Start the machine as described in the previous
paragraph.
2. Keeping both hands on the handlebar (2, Fig. C),
manoeuvre the machine and start the floor
scrubbing/drying.
DANGER!
Be careful: the rotating brush must not come in
contact with the supply cable (23, Fig. C) while
the machine is working.
Different speed can be selected by turning the adjusting knob
(17, Fig. H).
CAUTION!
To avoid any damage to the floor surface, stop
the brush rotation by means of the switch (2,
Fig. B) when the machine stops in one place.
CAUTION!
Before lifting the brush/pad-holder, stop its
rotation by means of the switch (2, Fig. B).
Machine drive controls
3. Depending on the floor type, or on the use of the brush
or the pad-holder, the machine front drive speed and the
forward straightaway movement (without turning on the
right or on the left) can change.
They can be adjusted by means of two knobs (16 and
17, Fig. H) on the brush-holder, proceeding in the
following way:
– The machine moves towards the left by turning the
adjusting knob (16, Fig. H) counter-clockwise; the
machine moves towards the right turning the
adjusting knob clockwise.
– The machine speed increases by turning the
adjusting knob (17, Fig. H) counter-clockwise; the
machine speed decreases turning the adjusting knob
clockwise.

TANK EMPTYING

NOTE
An automatic float cut-off system (8, Fig. H)
locks the vacuum system once the recovery
tank (5) is full.
The vacuum system locking is signaled by a
sudden increase in the vacuum motor noise
frequency.
Once the recovery water tank (5, Fig. H) is full, empty it in the
following way.
Micromax™ 17E — 909 5473 000(2)2005-04
All manuals and user guides at all-guides.com
INSTRUCTIONS FOR USE
Recovery water tank emptying
1. Stop the machine by means of the brush and vacuum
switches (2 and 3, Fig. B).
2. Disengage the supply plug (22, Fig. C) from the
electrical mains socket and roll the cable (23).
3. Lift the brush/pad-holder by means of the pedal (20, Fig.
C).
4. Lift the squeegee by means of the lever (19, Fig. C).
5. Bring the machine to the appointed disposal area.
6. Empty the recovery tank by means of the hose (17, Fig.
C). If the cleaning is over, rinse the tank with clean water.
Solution tank emptying
7. Carry out steps from 1 to 4.
8. Empty the solution tank by means of the hose (18, Fig.
C). If the cleaning is over, rinse the tank with clean water.

AFTER USING THE MACHINE

At the end of the work, before leaving the machine:
1. Disconnect the brush in the following way:
with the brush lifted, turn the brush switch (2, Fig. B)
to "I" position; after a few seconds, turn the switch
back to "0" position, releasing the brush.
2. Empty the tanks (5 and 6, Fig. H), following the
instructions in the previous paragraph.
3. After using the machine, perform the maintenance
operations (see the Maintenance chapter).
4. Leave the machine in a dry and clean place, with brush
and squeegee removed or lifted.

FIRST PERIOD OF USE

After the first period of use (first 8 hours) it is necessary to
check that the fastening and connecting elements are
correctly tightened, that the visible parts are integral and that
there are no leaks.
7