MINN KOTA MKA-32 Guide Rapide page 8

6
h. Place the hardware on the Damper side of the
mount into the Mounting Holes to secure the
Base Extrusion.
i. Install the motor with the Hex Head Bolts
(#2203431) and Clipped Washers (#2201725).
Orientate the Clipped Washers so that the flat side
of the washer is towards the Base Extrusion. The
Bolt should pass through the Clipped Washer, Base
Extrusion and into the Top Plate. Do not over-tighten.
7
j. At this point in the installation process, the Motor
should be secured to the Top Plate Assembly. The
Motor can now be reassembled. Slide the Extension
Damper back in place on the Damper Pins. This
should be done so the shaft on the Damper is
pointing inboard. Reinstall the two 5/16" E-clips.
8
k. Replace the Right Sideplate.
l. Replace the Left Sideplate.
m. Replace the four sideplate Screws using a #2 or #3
Phillips Screw Driver.
8l
Left Sideplate Left Sideplate
Screw Screw
8 | minnkotamotors.com
Screw Screw
6h
Mounting Holes Mounting Holes
6i
Hex Head Bolt Hex Head Bolt
Clipped Clipped
Washer Washer
Mounting Mounting
Holes Holes
Top Plate Top Plate
E-clips E-clips
8k
Screw Screw
Damper Pins Damper Pins
Extension Extension
Damper Damper
Screw Screw
Right Sideplate Right Sideplate
©2020 Johnson Outdoors Marine Electronics, Inc.