MINN KOTA MKA-32 Guide Rapide page 4

2
b. For applicable motors, remove the four sideplate
screws using a #3 Phillips screwdriver. Two of these
screws will be located on each side of the mount.
c. Remove the Right Sideplate.
d. Swing the Left Sideplate out and away from the
Base Extrusion. Removing the sideplates exposes
the Mounting Holes in the Base Extrusion.
2b
Mounting Mounting
Holes Holes
3
e. On the Bottom Plate, take note of the Cam Lever
attached to the plate. When the Bracket Assembly
is attached to the Base Extrusion, the end with the
Cam Lever will mount on the same end the Power
Cord exits the base of the Mount.
f. Align the Mounting Holes in the Top Plate with the
Mounting Holes in the Base Extrusion that were
exposed when the sideplates were removed. Make
sure that the Cam Lever is located on the mount
closest to the Power Cord and facing inboard.
The appearance of your Base Extrusion may vary
depending on motor type.
4
ITEM(S) NEEDED
g. Use the six 1/4" x 5/8" Screws (Item #18) to fasten
the Top Plate to the bottom of the Base Extrusion.
h. For motors where the sideplates were removed, re-
install both sideplates. Secure the Screws using a #3
Phillips Screwdriver.
4 | minnkotamotors.com
Right Sideplate Right Sideplate
#18 x 6
2c
Base Extrusion Base Extrusion
Left Sideplate Left Sideplate
3e
Power Power
Cord Exit Cord Exit
Top Plate Top Plate
Cam Cam
Lever Lever
4g
Base Base
Extrusion Extrusion
Inboard Inboard
Base Base
Screw Screw
Extrusion Extrusion
Top Plate Top Plate
©2020 Johnson Outdoors Marine Electronics, Inc.