MINN KOTA MKA-32 Guide Rapide page 10

3
e. Mark the side edges and rear of the Bottom Plate on
the bow of the boat.
f. Remove the Pin and unlatch the Cam Lever to remove
the Top Plate and Motor from the Bottom Plate.
NOTICE:
The mounting surface for the Bottom Plate
must be completely flat. Rubber Washers (Part #2301720)
can be used to shim the Bottom Plate flat before hardware
is tightened. The Top Plate will not fit correctly unless the
Bottom Plate is installed completely flat.
4
g. Reposition the Bottom Plate on the marks made on
the bow of the boat. Make sure the Padlock Slot and
Cam Lever are facing inboard.
h. Locate the six mounting holes in the Bottom Plate
and mark them on the bow. It is recommended to
use all six bolts to mount the Bottom Plate. Set the
Bottom Plate aside.
i. Drill through the deck of the boat using a 9/32" Drill
Bit on the marked locations.
5
ITEM(S) NEEDED
j. Align the Bottom Plate with the drilled holes.
k. Put a 1/4-20 X 2" Flat Head Screw (Item #17) in
each of the six drilled locations. The Bolts should
pass through the Bottom Plate then the boat deck.
l. Place a Flat Washer (Item #20) and then a Nylock
Nut (Item #19) at the end of each Bolt and tighten
with the 7/16" Box End Wrench. Make sure all
hardware is secure.
10 | minnkotamotors.com
#17 x 6 #19 x 6
3e
Outboard Outboard
Bow of Bow of
Boat Boat
Inboard Inboard
Markings Markings
4g
Outboard Outboard
Inboard Inboard
Cam Cam
Padlock Slot Padlock Slot
Lever Lever
#20 x 6
5k
Flat Head Flat Head
Screw Screw
Bottom Plate Bottom Plate
Assembly Assembly
Boat Boat
Deck Deck
Flat Flat
Washer Washer
Nylock Nut Nylock Nut
3f
Cam Lever Cam Lever
Inboard Inboard
4h
Mounting Mounting
Holes Holes
Mounting Mounting
Holes Holes
Keel Keel
©2020 Johnson Outdoors Marine Electronics, Inc.