• Some camera settings will return to the factory default settings if
the camera is left for about one hour with the battery removed.
Note
Inserting/Removing a card
"Card" in this manual refers to the xD-Picture Card. The camera uses the
card to record pictures.
●Inserting a card
1
Make sure that:
• The lens barrier is closed.
• The monitor is off.
• The lamps on the right of the viewfinder are off.
2
Open the card cover.
3
Face the card the correct way and insert it into the card slot as
shown.
• Insert the card while keeping it straight.
• When the card is inserted fully, you will feel it lock into place.
• Inserting the card the wrong
way or at an angle could
damage the contact area or
cause the card to jam.
• If the card is not inserted all
the way, data may not be
written to the card.
4
Close the card cover.
●Removing the card
1
Make sure that:
• The lens barrier is closed.
• The monitor is off.
• The lamps on the right of the viewfinder are off.
2
Open the card cover.
3
Push the card all the way in to unlock it, then let it return slowly.
• The card is ejected a short way and then stops.
4
Hold the card straight and pull it out.
5
Close the card cover.
When the card is inserted properly.
Card cover
Notch
Index area side
Getting started
En
11